NewTechWood UH02-16-WN-S Installationsanleitung PDF herunterladen (Seite 8)

Fascia Board

First make sure you know which type of installation you

are doing for your fascia board. There are two types:

Option 1: Installing against the length of decking

1. First the distance from where the board is locked to

the end of deck where the fascia board is to be

installed needs to be measured

2. After measuring remember that your gapping will be

2mm/meter from the locking clip.

3. Since there will be a gap at the end of the deck an

extra piece of wood will need to be added at the end

of the joist to make up the gapping distance.

4. The fascia board will now be installed into the block

of wood and into the joist as show in Diagram 13

Option 2: Installing against the width of decking

1. If you have installed where the edge of the board

hangs over the joist a block of wood will need to be

used under as shown in Diagram 15. If you have

installed where the edge of the board is ﬂush with the

joist than the fascia will just be installed through the

joist as shown in Diagram 16

2. First pre-drill the holes for the fascia board. The

fascia board should be drilled with bigger holes or

routed to allow for expansion and contraction and

ﬁxed either at either end or in the middle as shown in

Diagram 17. When ﬁxing the bigger holes it is

recommended to use washers.

3. The fascia board will be installed into the the block

wood and through the joist.

Note: NEVER install the fascia by drilling into the

decking as shown in Diagram 14. ALWAYS install the

fascia into the joist. ALWAYS pre-drill the fascia

board

UltraShield

Decking Installation Instructions

Diagram 13 Diagram 14

Diagram 15 Diagram 16

Diagram 17

1 2 3 4 5 6 7 8 9 10 11

Keine Kommentare

NewTechWood UH02-16-WN-S Installationsanleitung Seite 8